C. Install on a physical server/PC
Read and check the box to accept the Microsoft Software License Terms. Click Next . enuswindowsserver2022x64dvd620d7eaciso install
If you need to change your edition from an evaluation state to retail standard, execute: If you need to change your edition from
First, ensure your hardware meets the minimum requirements for a smooth installation. The same requirements apply to both the Standard and Datacenter editions. As outlined in official Microsoft documentation, the baseline requirements are as follows: select "Repair your computer
| Error Message / Issue | Most Likely Cause | Troubleshooting Steps | | :--- | :--- | :--- | | | The Windows installer does not have the necessary driver for your storage controller (e.g., RAID, NVMe). | 1. Download the correct storage drivers from your hardware manufacturer's support site (e.g., Dell, HPE). 2. Extract the drivers to a folder on a separate USB drive. 3. On the drive selection screen, click "Load driver" and browse to the USB drive containing the drivers. | | "Windows cannot find the Microsoft Software License Terms" | Often caused by a corrupted ISO file, an improperly created bootable USB, or incorrect BIOS/UEFI settings. | 1. Verify your ISO's integrity : Check its SHA-256 hash against the official Microsoft value (if available). 2. Recreate your bootable USB : Use a tool like Rufus to create the drive again, ensuring it's formatted correctly. 3. Check BIOS/UEFI settings : Ensure Secure Boot is not causing a compatibility issue and that the boot order is set to prioritize the USB/DVD drive. | | The installation fails or freezes at a specific point | Could be due to faulty hardware (RAM, hard drive) or a corrupted installation source. | 1. Run hardware diagnostics : Most server manufacturers (Dell, HPE, Lenovo) include built-in hardware diagnostic tools. Run these to test your RAM and storage drives. 2. Redownload the ISO : If you suspect a corrupt download, delete the file and download a fresh copy from Microsoft directly. | | Errors when installing Windows Updates after setup | Sometimes a specific registry key or file corruption can block updates. | 1. Run the DISM tool : Run DISM /Online /Cleanup-Image /RestoreHealth from an elevated Command Prompt to repair system files. 2. Run the System File Checker : After DISM, run sfc /scannow to verify and restore protected system files. | | The server won't boot after installation | The boot order in BIOS/UEFI might be set to the installation media, or the bootloader could be corrupted. | 1. Check boot order : Ensure the hard drive is the first boot device in your BIOS/UEFI settings. 2. Perform a startup repair : Boot from the installation ISO, select "Repair your computer," and then choose "Startup Repair." |