You can still update the maps on your 9.1.3 system using the official MediaNav Evolution Toolbox . Insert a FAT32-formatted USB drive (min 4GB) into your car.
Ships natively with firmware versions like 5.x.x, 6.x.x, 7.x.x, 8.x.x, and terminates officially at 9.1.3 . These hardware units run on the Windows Embedded CE 6.0 operating system.
However, a direct software-only update between these specific versions is technically impossible because .
Only then could they enjoy the 10.13.1 firmware and the modern connectivity they craved.
Dedicated tools, such as the available on GitHub, allow power users to extract the contents of an upgrade.lgu file, modify them, and then repackage them into a new LGU file. This is how many custom skins and mods are created. An LGU file is essentially a firmware update package used by these Windows CE 6.0-based systems. upgrade medianav 913 to 10131
This is a common issue where the progress bar freezes at 90%.
Because the architecture has changed from Windows to Linux, you cannot simply "flash" the 1.0.13.1 firmware onto a 9.1.3 device. Options for Your Unit (9.1.3)
While you cannot install the official Linux OS, you can expand the capabilities of your Windows CE unit using third-party custom firmware like or MediaNav Plus .
: The exterior plastic fascia and mount points must match your vehicle's dash (e.g., Renault Clio IV, Captur, Dacia Duster, or Kwid). You can still update the maps on your 9
These software add-ons run on top of Windows CE, giving you access to alternative navigation systems (like 7-Ways or Navitel), video players, and mirror-link capabilities.
Ensure your car battery is healthy. Keep the engine running during the entire installation process to prevent the car from entering "Eco Mode" and shutting down the radio.
You will need the radio code for the new unit.
Start your car engine. Never do this with the engine off, as a battery drop can break the unit. Turn on the MediaNav system. 3. Initiate the Update Insert the USB drive into the MediaNav slot. These hardware units run on the Windows Embedded CE 6
Re-verify that the file format is strictly FAT32. If it still fails, try using an older USB 2.0 drive, as some older MediaNav motherboards struggle to read high-speed USB 3.1 drives. The Screen is Stuck on the Logo (Bootloop)
Go to > System > System Version . It should now read 10.1.3.1 . Troubleshooting Common Issues
If you want, I can: