Wait until the display reads or the box automatically reboots. Remove the USB drive immediately to avoid a reboot loop. Troubleshooting Common Issues
Are you storing your backups on an or a USB stick ?
(the capacitive power button) on the far left of the front panel. Completion
By keeping an updated backup image of your VU+ Solo2 on hand, you ensure that your personalized viewing experience is completely protected against software bugs, accidental setting changes, or corrupted updates. To help you optimize your backup setup, could you tell me:
Flashing a new image is usually straightforward, but problems can occur. vu solo2 backup image
Your custom bouquets, satellites, and transponder settings.
: Never turn off the receiver during the process to avoid permanent damage. Step-by-Step Backup Guides by Image
Ensure the backup file is unzipped and located in the directory structure USBStick/vuplus/solo2 . The folder must contain root_cfe_auto.bin , kernel_cfe_auto.bin , and other necessary files. Power Off: Turn off the VU+ Solo2 using the rear switch. Insert USB: Plug the USB stick into the front USB port. Power On: Turn the box back on.
Select your storage device (HDD or USB) and press (Green button) to start. OpenViX : Press Menu > Setup > Vix > Image Manager . Press the Green button (New Backup). Wait until the display reads or the box
Turn off your VU+ Solo2 using the deep standby mode or flip the power switch at the back of the box.
These are the safest options if you are experiencing stability issues. They come without any 3rd party plugins installed.
is praised for its "outstanding" cold boot time of , a benchmark that was revolutionary for Linux-based receivers when it launched.
The exact menu paths vary slightly depending on the Enigma2 image you run (OpenATV, BlackHole, or OpenVIX). Below are the methods for the most widely used firmware options. Method 1: OpenATV Image Press the button on your remote control. Navigate to Setup > Software Management > Full Backup . (the capacitive power button) on the far left
Note: Do not rename any of these files, or the VU+ Solo2 bootloader will fail to recognize them during a restore. How to Restore / Flash Your Backup Image
Note: If these files are zipped, extract the vuplus folder directly to the root directory of your USB drive before attempting to flash. How to Restore / Flash Your Backup Image
Press the Menu button on your remote control.