Ccna-2v7.0 Case Study -rev B- Updated -

By following these steps and tips, you'll be well on your way to completing the CCNA 2 v7.0 case study - Rev B successfully. Good luck!

Security is a priority from the start. On all routers and switches (like CHG-RTR, PHX-SW-1, and BAN-RTR), you must:

Use show ip route and show ipv6 route to ensure all routes are in the routing table. ccna-2v7.0 case study -rev b-

You are a network administrator for a company called "E-MAGINE". The company is merging with another entity and expanding to a Wide Area Network (WAN) with multiple locations. Your goal is to design and implement a network that ensures inter-VLAN communication, secure access, and efficient routing.

This in-depth article will guide you through the core components of a typical "Revision B" case study, detailing the essential technologies—from initial design to final implementation and verification. By following these steps and tips, you'll be

: Configuring EtherChannel for link aggregation and Spanning Tree Protocol (STP) to prevent loops.

Administrators must split a physical router interface into subinterfaces corresponding to each VLAN: On all routers and switches (like CHG-RTR, PHX-SW-1,

spanning-tree mode rapid-pvst spanning-tree vlan 10,20 root primary spanning-tree vlan 30,99 root secondary Use code with caution. 3. Inter-VLAN Routing & Redundancy

Pro-Tip: In both the case study and the actual certification exam, you will be heavily penalized if you forget to save your configurations. Always run copy running-config startup-config on every emulated device. 🚀 Modernizing the Network: Wireless & Automation

: Implementing router-on-a-stick or SVI-based routing to allow communication between different departmental VLANs. Phase II: Infrastructure Configuration EtherChannel