Xmtk9000 User Manual Upd |work| -

Used in On/Off control to prevent rapid cycling.

Bookmark the official support portal and set a calendar reminder to check for new UPDs every 6 months. For critical systems, subscribe to the manufacturer’s technical bulletin RSS feed.

Before installation, ensure your unit matches your power supply requirements: 85–265V AC (Standard) or 24V DC (Optional) xmtk9000 user manual upd

Main Control Output (Relay: Common/NO/NC; SSR: +/-). Terminals 6-7: Alarm Output 1 (ALM1). Terminals 8-10: Sensor Input. For Thermocouples: Connect + to 9 and - to 10.

! Whether you're integrating it into a new DIY setup or maintaining an existing line, this guide is your go-to for: ✅ Accurate ±0.5% FS measurement setup. Used in On/Off control to prevent rapid cycling

Do not alter the system while the controller cycles the heat to calculate the thermal dynamics.

If using a 3-wire PT100, connect the third compensation wire to Terminal 10. Output Connections Before installation, ensure your unit matches your power

I can provide the exact terminal mapping or parameter sequence for your setup.