Ikegami Bsf-300 Manual

Connect the SMPTE fiber cable from the camera head to the CAMERA port on the BSF-300 rear panel.

Adjust settings based on the length of the fiber or triax run to optimize signal integrity and power delivery.

Simultaneous support for HDTV (1080i 50/60, 720p 50/60, 1080psF25) and SDTV (625i 50, 575i 60) in both digital and analog domains.

If you are referencing the manual for an error, check these common areas: Optical Alarm: ikegami bsf-300 manual

is a highly efficient, affordable 1.5 RU Fiber Base Station designed to deliver uncompressed, high-quality HD and SD imagery over short and medium distances . It bridges the gap between field camera heads—such as the Ikegami HDK-73 and HC-HD300 —and production switchers. Whether setting up a new studio, configuring an outside broadcast (OB) van, or deploying a flypack, mastering the manual configurations of this equipment is vital to maintaining operational efficiency. Core Specifications & System Variations

Toggle through the pages to configure audio gain settings, aspect ratios, down-conversion parameters, and tally logic. Fiber Cable Status Codes

Features Neutrik opticalCON DUO connectors for 1.5G fiber-hybrid transmission. Connect the SMPTE fiber cable from the camera

Once powered on, the BSF-300 provides multiple ways to manage the system:

Ensure the main AC power switch on the BSF-300 is in the "OFF" position.

Ensure the "Genlock" input is receiving a valid reference signal (Black Burst or Tri-Level Sync) to keep the camera in phase with the rest of the production. Power Fault: If you are referencing the manual for an

Allows local monitoring of production or engineering intercom channels directly at the rack frame. Rear Panel Connectivity The rear panel houses the critical I/O infrastructure:

: It simultaneously supports HDTV (1080i, 720p) and SDTV (625i, 575i) formats in both digital and analog domains. Transmission Distance :

(32,800 ft) using duplex single-mode fiber with local power for the camera. Connectivity Options : BSF-300 : Equipped with Neutrik OpticalCON DUO connectors.

Leave at least 1U of space above or below if operating in high-temperature environments. 2. Cable Connections