Ch-899 Chouchin Radio Controlled Clock Instructions 🎁 Pro

This means the clock is actively trying to receive the atomic signal but cannot find it.

If successful, the clock will update to the correct time within a few minutes. 4. Troubleshooting and Tips

Although your CH-899 is a radio-controlled clock, there are times when you might need to set the time by hand, such as when replacing batteries or if the radio signal is temporarily unavailable. This process varies slightly between models:

Press and hold the button for roughly 3 to 5 seconds. The minute hand will start to move. ch-899 chouchin radio controlled clock instructions

Elias popped the cover off the back. The manual read: “Insert one AA battery (not included) according to the polarity. The clock will start to run.”

: Once the signal is received, the hands will automatically advance to the correct time. TLC Electrical Supplies Control Features Time Zone Switch : Found on the back, usually with settings for (Pacific), (Mountain), (Central), and (Eastern). REC (Force Receive) : Press and hold for to manually force the clock to search for a signal. M. SET (Manual Set) : If no signal is available, hold this button for

: Some newer CH-899 movements use WiFi instead of radio signals. These require connecting to a mobile phone and entering a configuration page (typically 192.168.4.1 ) to set the SSID and password. MSF Radio Controlled Wall Clock - TLC Electrical Supplies This means the clock is actively trying to

Night fell. The room grew cold. Arthur wrapped a blanket around his shoulders. He sat on the armchair by the window, the CH-899 perched on his knee. The antenna icon was still flashing, a desperate little heartbeat.

Before starting, locate the three primary control buttons on the back of the clock movement:

The clock automatically attempts to receive signals up to 14 times a day. 2. Initial Setup: Installing Batteries Troubleshooting and Tips Although your CH-899 is a

If your CH-899 refuses to sync automatically, ensure it is kept away from: Domestic appliances (microwave ovens, refrigerators)

: To force the clock to look for a signal immediately, press and hold the REC button for at least 3 seconds . The hands will return to 12:00 and begin a new search.

Note: Even if you set the time manually, the CH-899 will still attempt to search for the atomic signal overnight. If it finds a signal, it will override your manual setting to ensure perfect accuracy. Forced Signal Reception (REC Mode)

If you are in a "dead zone" or need to override the atomic signal, follow these steps: Enter Manual Mode : Press and hold the button for about 3 seconds until the second hand stops. Adjust Time button repeatedly to advance by 1 minute at a time. Hold the button down for quick advance Save and Exit

The hands will stop exactly at , 4:00 , or 8:00 (depending on the specific firmware version).