Schindler 5500 Error Codes Free ((better)) Link

| Code | Description (typical) | |------|------------------------| | | Drive fault – inverter overload | | 0204 | Door open time exceeded | | 0301 | Car – floor position lost (PPR error) | | 0412 | Brake contactor feedback error | | 0505 | Safety chain open (non-emergency) | | 0603 | Car communication timeout (CAN bus) | | 0702 | Door lock circuit failure | | 0801 | Speed reference deviation | | 0909 | Emergency brake test required | | 1006 | Battery low (emergency light/inverter) |

SB contactor is energized while the car is at a standstill. Check the auxiliary contacts of the SB contactor for incorrect feedback or manual operation. 0013 (OverSpeed): Detected overspeed condition. 0444 (Trip Timeout):

Find the small liquid crystal display board on the main controller interface.

Schindler 5500/6600 LMS Adjustment Guide | PDF | Elevator - Scribd

| Code Range | System Area | |------------|--------------| | 0000–0999 | Door Operator (DO) | | 1000–1999 | Drive & Inverter (VWF) | | 2000–2999 | Car & Position Reference | | 3000–3999 | Safety Chain & Brake | | 4000–4999 | Group Control (multiple cars) | | 5000–5999 | Communication (CAN bus, serial) | schindler 5500 error codes free

Troubleshooting Schindler Miconic TX and TX-GC | PDF - Scribd

Door failures represent over 50% of all elevator service calls. The Schindler 5500 uses advanced door operators that constantly monitor position and torque.

: Safety circuit is disconnected; check the SB/SB1 contactors or the brake module .

: Look for alternating messages on the control board screen. A blinking " 0444 (Trip Timeout): Find the small liquid crystal

The drive detected an electrical current spike exceeding safe thresholds.

When the elevator displays status 98, it requires a to clear the fault from the system memory and restart the system.

| Code | Description | Common Cause / Notes | | :--- | :--- | :--- | | | Car Communication Fault | Communication lost between the main controller and the car top or car operating panel. Check the traveling cable. | | 302 | Hall Communication Fault | Communication lost with hall lanterns or hall call stations. Check the CAN-bus/LAN wiring connections on the specific floor. | | 310 | Microprocessor Error | Internal fault in the main CPU board. May require a system reset or board replacement. | | 404 | Car Not Leveling | The car is trying to re-level but cannot find the floor position. Check leveling magnets/sensors. |

: Often related to incorrect magnet polarity in the shaft . : Safety circuit is disconnected; check the SB/SB1

Electrical noise, loose data cables, or a shorted landing call button disrupting the entire network bus.

: Unscheduled or unexpected car trajectory detected by the safety circuit.

The safety string monitors hoistway door locks, emergency stop buttons, and car top boundaries.